1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Cura profile

Discussion in 'Troubleshooting' started by Massimiliano, Apr 24, 2022.

  1. Massimiliano

    Massimiliano New Member

    Joined:
    Apr 24, 2022
    Messages:
    2
    Likes Received:
    1
    Hi guys! I have purchased a Robo r2 and i want to use cura as the slicer, but everytime i start a print It goes in the front left corner and start like purging on a line of 5 cm right to left and nothing more. What i'm doing wrong? G code flavor? I've left blank the start and end gcode Windows, maybe that's the problem? Thanks
     
    #1 Massimiliano, Apr 24, 2022
  2. Massimiliano

    Massimiliano New Member

    Joined:
    Apr 24, 2022
    Messages:
    2
    Likes Received:
    1
    I found the problem, was the "origin at center", i had to switch It Off.
     
    #2 Massimiliano, Apr 25, 2022
    mark tomlinson likes this.

Share This Page