1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Cura Settings

Discussion in 'Software' started by Tanner Ricketts, Oct 22, 2017.

  1. Tanner Ricketts

    Tanner Ricketts New Member

    Joined:
    Oct 22, 2017
    Messages:
    2
    Likes Received:
    0
    I am interested in trying to set up a print one at a time option in Cura and I was wondering what the settings are. I have listed below what I need to figure out. Thank you
    upload_2017-10-22_16-53-22.png
     

    Attached Files:

    #1 Tanner Ricketts, Oct 22, 2017
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    What version of cura are you using? I use 2.6.2 and 3.0 for my ultimaker and the setting is under Special modes- Print Sequence. Your see options of all at once and one at a time.

    A word of advice- make sure you have your printers carriage dimensions set up appropriately otherwise its a huge problem that typically breaks something.
     
    #2 Geof, Oct 23, 2017
  3. Tanner Ricketts

    Tanner Ricketts New Member

    Joined:
    Oct 22, 2017
    Messages:
    2
    Likes Received:
    0
    I use 15.04.6. Yes I am fully aware that this is not the current version I just like this version best. in this version the "tools" tab holds the options "print all at once" or "Print one at a time." I am using the Robo 3d r1 machine settings cura provides upon set up (not custom)
     
    #3 Tanner Ricketts, Oct 23, 2017
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Print one at a time sounds like what your after
     
    #4 Geof, Oct 23, 2017

Share This Page