1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

diamond hot end

Discussion in 'General Questions' started by allan arthur, Aug 31, 2017.

  1. allan arthur

    allan arthur New Member

    Joined:
    Sep 10, 2015
    Messages:
    9
    Likes Received:
    2
    has any one thought about putting a diamond hot end on the r1 plus it has 3 in one out design. if so have you got it working i am thinking about this.
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    No havent thought about it. But you'd have to expand the E slots and adjust the firmware then find somewhere to mount the 3 bowden extruders on the robo frame that is rigid/strong enough to support the extrusion/retraction force....then figure out how to adjust the firmware and add a customer switching script to your slicer.

    To much headache for me :D
     
  3. OutsourcedGuru

    OutsourcedGuru Active Member

    Joined:
    Jun 3, 2017
    Messages:
    752
    Likes Received:
    141
    From here, Cura's not compatible with more than two extruders so you'd probably want S3D perhaps if you wanted to go there.
     

Share This Page