1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Disconnected cable

Discussion in 'Troubleshooting' started by Jutte, Apr 12, 2016.

  1. Jutte

    Jutte Member

    Joined:
    Apr 5, 2016
    Messages:
    47
    Likes Received:
    19
    I just discovered a cable that was sitting at the left side unconnected to anything. I have been printing and had no issues other than filament clogging. Anybody know if this should be hooked up to something? This is a refurbished R1 I just received last week
    . cable.jpg
     
  2. Chuck Erwin

    Chuck Erwin Active Member

    Joined:
    Aug 27, 2015
    Messages:
    202
    Likes Received:
    136
    You are looking at it from the front and that is on the left:

    What is connecting your left limit switch?
    Look on the other side is the right switch wired up? two wires to the switch facing you.
     
  3. Jutte

    Jutte Member

    Joined:
    Apr 5, 2016
    Messages:
    47
    Likes Received:
    19
    There is nothing connected to the left limit switch. The right limit switch is wired.
     
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Call Robo and speak to their tech support. There should be a switch on both sides and it should have wires connected to the outside two terminals in both cases. If not then they should be able to sort it out for you as their refurbished units should carry the same warranty as brand new ones.
     
    Jutte likes this.
  5. Jutte

    Jutte Member

    Joined:
    Apr 5, 2016
    Messages:
    47
    Likes Received:
    19
    Thanks all. I took a closer look and got it sorted out. The wires on that side must have gotten dislodged, back in place now.
     

Share This Page