1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Do you need abs prints ?

Discussion in 'Off Topic' started by Geof, Nov 10, 2016.

  1. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Hey guys,
    Ive got a zortrax m200 ive been playing with and have managed to get abs working reliably on it. If your in need of something printed in abs get ahold of me. As of right now i havent had a single warping issue which was unobtainable on my other printers. Figured id throw it out there :)
     
    #1 Geof, Nov 10, 2016
    Chuck Erwin, WheresWaldo and mark tomlinson like this.
  2. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    Did you ever try using an enclosure on the Robo for ABS? I think temp stability is key from what I read.
     
    #2 danzca6, Nov 10, 2016
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I figured id leave my robo as is. I dont like the enclosures. I use to stick a printer in the closet (about 80 deg with a space heater) but i still had some warping on large parts. The zortrax prints on a wierd pcb board with holes and a raft (wont print without one and you have zero control of the slicer) but it just works lol
     
    #3 Geof, Nov 10, 2016

Share This Page