1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Drooping Heat Pad an issue?

Discussion in 'General Questions' started by kain0r3D, Dec 13, 2016.

Thread Status:
Not open for further replies.
  1. kain0r3D

    kain0r3D New Member

    Joined:
    Mar 30, 2016
    Messages:
    25
    Likes Received:
    2
    Hi all,

    The heating pad under my glass seems to be drooping off the glass in the middle slightly where it's not taped. Should I be concerned?

    If so, what's the move here, is there a way to remedy it?
     
    #1 kain0r3D, Dec 13, 2016
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    There have been many ways tried, none of them are permanent. It is not really a big issue unless it is snagging on the belts.
     
    #2 WheresWaldo, Dec 14, 2016
  3. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    Is it the heat pad or the sheet of cork? If it's just the cork, what I did was go out to the hardware store and buy HVAC Aluminum tape similar to this http://a.co/0tW0i4W and placed strips of it across the whole cork board. I went both directions since I had a ton. It's held well for me for over a year without any issues. Like WW mentioned above, the drooping could end up causing issues with it getting caught on components under the bed.
     
    #3 danzca6, Dec 14, 2016
    mark tomlinson likes this.
  4. kain0r3D

    kain0r3D New Member

    Joined:
    Mar 30, 2016
    Messages:
    25
    Likes Received:
    2
    Yup, looks like just the cork. I'll tape it up!

    Cheers.
     
    #4 kain0r3D, Dec 14, 2016
Thread Status:
Not open for further replies.

Share This Page