1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

E3D Hot End Parts

Discussion in 'Mods and Upgrades' started by Michael DiFilippo, Sep 18, 2013.

  1. Michael DiFilippo

    Michael DiFilippo Active Member

    Joined:
    Feb 20, 2013
    Messages:
    400
    Likes Received:
    140
    Hey guys,
    So I got my e3D hot end and was an idiot while assembling. Pretty much I need a new heater block, nozzle, and heat break. I emailed E3D Sunday and again yesterday still with no response. ANyone know if I could get those parts IN the US? Not sure if they are standard or if the guys at E3D did them custom.

    Thanks!
     
    #1 Michael DiFilippo, Sep 18, 2013
  2. Leon Grossman

    Leon Grossman Active Member

    Joined:
    Feb 20, 2013
    Messages:
    226
    Likes Received:
    123
    Those are all custom parts. You're going to have to get them from the E3D guys but I've found them to be responsive.
     
    #2 Leon Grossman, Sep 18, 2013
  3. Michael DiFilippo

    Michael DiFilippo Active Member

    Joined:
    Feb 20, 2013
    Messages:
    400
    Likes Received:
    140
    Thanks Leon, I had a feeling they were custom. I find it strange that I haven't heard back unless they don't always monitor emails .
     
    #3 Michael DiFilippo, Sep 18, 2013
  4. tesseract

    tesseract Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    1,924
    Likes Received:
    533
    So what did you do to mess all that up, Mike???
     
    #4 tesseract, Sep 26, 2013
  5. Michael DiFilippo

    Michael DiFilippo Active Member

    Joined:
    Feb 20, 2013
    Messages:
    400
    Likes Received:
    140
    Some how managed to way over tighten during assembly (something i WILL NOT do again). Just waiting on the new parts to come in now, should have them this week. Its been way too long since I've used the printer so I can't wait to get them in
     
    #5 Michael DiFilippo, Sep 28, 2013

Share This Page