1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved E3D nozzle on stock hotend

Discussion in 'General Questions' started by Dylan Zilifian, Jun 15, 2017.

Thread Status:
Not open for further replies.
  1. Dylan Zilifian

    Dylan Zilifian New Member

    Joined:
    Jun 6, 2017
    Messages:
    9
    Likes Received:
    2
    Is it possible to put an E3D nozzle on a stock hotend or will I have to buy a new hotend to go with it?
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    E3D nozzles fit the Hexagon just fine as long as they are not volcano nozzles.
    If they are they will say so.
     
Thread Status:
Not open for further replies.

Share This Page