1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

E3D PT100, how to install and configure

Discussion in 'Mods and Upgrades' started by robert sanchez, Feb 29, 2016.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. Rascal

    Rascal Member

    Joined:
    Apr 25, 2016
    Messages:
    31
    Likes Received:
    2
    #21 Rascal, Sep 25, 2016
  2. Rascal

    Rascal Member

    Joined:
    Apr 25, 2016
    Messages:
    31
    Likes Received:
    2
    #22 Rascal, Sep 25, 2016
  3. Hman84

    Hman84 New Member

    Joined:
    Sep 24, 2016
    Messages:
    2
    Likes Received:
    0
    that is not the problem? i have some issue with marlin
    i use this github.com/Ultimaker/Ultimaker2Marlin and get when i want to upload the firmware this error:
    exit status 1
    'motor_current_setting' was not declared in this scope
     
    #23 Hman84, Sep 25, 2016
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,340
    While there are members here that may be helpful specific questions regarding ultimakers, marlin etc would be easier answered in their forums
     
    #24 Geof, Sep 25, 2016
  5. Rascal

    Rascal Member

    Joined:
    Apr 25, 2016
    Messages:
    31
    Likes Received:
    2
    You will have to contact utilimaker, it may require a jumper or resistor or you have to do something else, I had a few issues with my robo when I installed, but I had to do some wire traces and re read alot and for me I had not edited the correct device parameters in the txt file. Good luck.
     
    #25 Rascal, Sep 25, 2016
  6. Michael Woodward

    Michael Woodward New Member

    Joined:
    Sep 23, 2017
    Messages:
    12
    Likes Received:
    3

    Would you be able to post some pics of what you ended up with? specifically how you added the 4x1 to the board.
     
    #26 Michael Woodward, Apr 8, 2018
  7. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    @Michael Woodward Joe Smith hasn't been on this board since Jan 2017. I highly doubt he will be able to respond.
     
    #27 WheresWaldo, Apr 8, 2018
  8. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,962
    Likes Received:
    7,344
    The guy who started the thread is even more gone : "robert sanchez was last seen: May 26, 2016"
     
    #28 mark tomlinson, Apr 8, 2018
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page