1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered Error Reported: "Printer stopped due to errors. Fix the error and use M999

Discussion in 'Troubleshooting' started by nowell, Jan 17, 2017.

  1. nowell

    nowell New Member

    Joined:
    Jan 17, 2017
    Messages:
    2
    Likes Received:
    0
    Has anyone figured out a fix for this? I am using an R1 Plus with ABS on Matter Control standard settings. The head stops at the upper right leveling and calibrating point and does not start the print. Temperatures are 235c and 80c. Have stopped program, unplugged printer, restarted computer, program and printer three times to no avail. ???
     
    #1 nowell, Jan 17, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Yes, but you first need to get the actual error from the GCode terminal.
    Scroll back all the way.

    this:


    "Printer stopped due to errors. Fix the error and use M999"

    is not the real error .. it is marlin being stupid and simply repeating over and over again that an error did in fact happen.
     
    #2 mark tomlinson, Jan 17, 2017
    Geof likes this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    My gut feeling is that your real error is "Temperature fell too much during print!"
    But make sure.
     
    #3 mark tomlinson, Jan 17, 2017
    Geof likes this.

Share This Page