1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Filament Status: Filament Has Run Out

Discussion in 'Troubleshooting' started by VigilantWookie, Apr 14, 2022.

  1. VigilantWookie

    VigilantWookie New Member

    Joined:
    Feb 6, 2020
    Messages:
    13
    Likes Received:
    0
    I keep getting this message when trying to run a print. There is still filament on the spool, and it is feeding into the hotend, but eventually, just stops. Any suggestions? I am curious if it misfeeding.
     
    #1 VigilantWookie, Apr 14, 2022
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    I am confused. The R1 does not have a runout sensor so there is no way for you to get this on a stock printer and you posted this in the R1 forum...

    If you added one you should be able to check it and see if it is working correctly.

    If this is another printer (perhaps a non-robo or an R2) then Bypass the runout sensor. The Robo R2 allows you to do this via the OctoPrint menu.

    See this for help if it is an R2:

    https://help.robo3d.com/hc/en-us/articles/115000715551-Error-Filament-runout
     
    #2 mark tomlinson, Apr 14, 2022

Share This Page