1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

First 3D printer!

Discussion in 'Introduction' started by gravityisweak, Oct 9, 2014.

  1. gravityisweak

    gravityisweak Member

    Joined:
    Oct 7, 2014
    Messages:
    53
    Likes Received:
    14
    Hi everyone, I just wanted to introduce myself. I've just received the R1 as a gift from my awesome girlfriend! It's my first 3D printer. I've done a few test prints so far and immediately ran into problems. I'm guessing the community here is going to be important to me, as this clearly has a learning curve to it. I look forward to learning 3D printing and I'm glad this community is here!
     
  2. mikej997

    mikej997 New Member

    Joined:
    Jul 16, 2014
    Messages:
    9
    Likes Received:
    0
    Welcome! Yes, this forum and the folks here are a great resource. If you need quick help there are a few resident jedi 3d print gurus that hang out on the Shoutbox - the live chat area of the website. I know the printer can take a bit of work to get running right, these guys will help get you there.
    Good luck!
     
  3. gravityisweak

    gravityisweak Member

    Joined:
    Oct 7, 2014
    Messages:
    53
    Likes Received:
    14
    Thanks for that! I didn't realize there was a Shoutbox!
     

Share This Page