1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

First print pla

Discussion in 'Show and Tell' started by wthierry, Jul 23, 2017.

  1. wthierry

    wthierry Active Member

    Joined:
    Dec 22, 2014
    Messages:
    185
    Likes Received:
    54
    Here is my first print after calibration in pla. Trying the same next in ABS, will post result.
     
    #1 wthierry, Jul 23, 2017
    Last edited by a moderator: Jul 23, 2017
  2. wthierry

    wthierry Active Member

    Joined:
    Dec 22, 2014
    Messages:
    185
    Likes Received:
    54
    calibrationpyramid.jpg
     
    #2 wthierry, Jul 23, 2017
    Tony Stadele likes this.
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Looks pretty good, might be a touch on the hot side.
     
    #3 Geof, Jul 23, 2017
  4. wthierry

    wthierry Active Member

    Joined:
    Dec 22, 2014
    Messages:
    185
    Likes Received:
    54
    Yea, going to lower it 5 degrees next time...
     
    #4 wthierry, Jul 23, 2017
    Geof likes this.
  5. supercazzola

    supercazzola Active Member

    Joined:
    Jun 1, 2017
    Messages:
    424
    Likes Received:
    111
    @wthierry what was the original temp? Did you slice with Cura? Mac or Windows?


    Sent from my iPad using Tapatalk Pro
     
    #5 supercazzola, Aug 12, 2017

Share This Page