1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered Getting bumps on ABS that throw off my extruder

Discussion in 'Troubleshooting' started by castmemberzack, Jul 14, 2016.

  1. castmemberzack

    castmemberzack Member

    Joined:
    Apr 2, 2016
    Messages:
    106
    Likes Received:
    5
    http://m.imgur.com/Qv2kWqbkWqb

    The middle and outside of the prints are fine. It's when it gets to those edgez that it lifts up on one side and not the other (the other gets adheard down like it's supposed to)

    R1+, simplify, hatchbox ABS, enclosed in a mini green house.
     
    #1 castmemberzack, Jul 14, 2016

Share This Page