1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Glueing PLA quickly and filling cracks

Discussion in 'Printing Filament' started by wthierry, Dec 22, 2015.

  1. wthierry

    wthierry Active Member

    Joined:
    Dec 22, 2014
    Messages:
    185
    Likes Received:
    54
    Not sure if this has been shared, but I have found that if you use super glue to glue pla together, take a small paintbrush and dip it in baking soda, brush on the seam the glue sets almost immediately. Works great for filling cracks too. just dont get it on your skin! Let me know if this works for anyone!
     
    NerdMomma and Mike Kelly like this.
  2. TylerJ

    TylerJ New Member

    Joined:
    Dec 16, 2015
    Messages:
    11
    Likes Received:
    1
    I've used Gorilla Super Glue and works just as well.
     
    WarDarkFox likes this.
  3. E-Z

    E-Z New Member

    Joined:
    Jan 27, 2016
    Messages:
    9
    Likes Received:
    1
    i herd some thing about that with baking soda, if i recall right this stuff get hard as a rock,
    i mean so hard its really rock hard
     

Share This Page