1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

gr8se prints

Discussion in 'Show and Tell' started by gr8se, Apr 16, 2014.

  1. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    Do you have drawer slides or rod and bearing?

    Make sure that none of the wires are getting in the way
     
  2. gr8se

    gr8se New Member

    Joined:
    Jan 25, 2014
    Messages:
    31
    Likes Received:
    7
    hey mike,

    I have the drawer slides. Wires are good.
     
  3. gr8se

    gr8se New Member

    Joined:
    Jan 25, 2014
    Messages:
    31
    Likes Received:
    7
    even with the y axis belt off i cannot physically move the bed to its stop.

    take the bed off the slides and reset it?
     
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    yeah the slides have been known to fail. That's why the R1 has linear rods and bearings.
     
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    That was the process.

    I agree the linear rods/bearings are a better idea.
     
  6. gr8se

    gr8se New Member

    Joined:
    Jan 25, 2014
    Messages:
    31
    Likes Received:
    7
    I took the bed off and its the right side slide that is jamming. The plastic? along either side of the rail is only moving 6". What's the process now for the slides?
     
  7. gr8se

    gr8se New Member

    Joined:
    Jan 25, 2014
    Messages:
    31
    Likes Received:
    7

Share This Page