1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Heated Bed Warping?

Discussion in 'Troubleshooting' started by DavidTheNerd, May 20, 2017.

  1. DavidTheNerd

    DavidTheNerd New Member

    Joined:
    May 31, 2016
    Messages:
    9
    Likes Received:
    1
    My heated bed is getting the cork scraped off as I print. It seems to be making contact with the belt guide screws. I would like to know how I should fix it. I will attach a picture so you can see just how bad it has gotten. [​IMG]
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,668
    Likes Received:
    7,316
  3. DavidTheNerd

    DavidTheNerd New Member

    Joined:
    May 31, 2016
    Messages:
    9
    Likes Received:
    1
    Well, my cork is so torn up that I need to replace it, is it simply 1/16 thick cork? I did notice it had adhesive on it. Is it something I would have to buy special or can I just tape it up well?
     
    Jeff4Smith likes this.
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,668
    Likes Received:
    7,316
    Just tape it. it is nothing other than cork sheet... 1/8" if memory serves
     
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,668
    Likes Received:
    7,316
    You could replace it with any insulation you like :)
     
    DavidTheNerd likes this.

Share This Page