1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Hello from Elkhorn, WI

Discussion in 'United States of America' started by mcsams, Nov 25, 2016.

  1. mcsams

    mcsams New Member

    Joined:
    Feb 17, 2016
    Messages:
    11
    Likes Received:
    2
    I got my R1+Plus last January and have been following this forum regularly with great interest. I have made some hardware mods but mainly focus on the Marlin Firmware Upgrade 1.1.0 RCBugFix (Post RC7) (For R1 & R1+PLUS) thread. I tend to print objects that are challenging and then bring it work, needling my colleague to do the same on his non-Robo3d printer. Good times!!!!
     
    mark tomlinson likes this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,668
    Likes Received:
    7,316
  3. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    Elkorn has one of my favorite car shows every year. Welcome to the forum! The new firmware is awesome. Are you using ABL or MESH? If not MESH, you should try it.
     
  4. mcsams

    mcsams New Member

    Joined:
    Feb 17, 2016
    Messages:
    11
    Likes Received:
    2
    I've never been. Is it at the fair grounds?

    Yes, the new firmware is definitely better than the stock. It didn't take me long to upgrade and of course I had to get S3D. I opted for MESH and it has been great. I was not a fan of the printer doing ABL prior to each print.

    Thanks for the welcome guys!
     
  5. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    Yes it is at the fairgrounds the first weekend of August or somewhere around there.
     

Share This Page