1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unanswered Help me fix my Print

Discussion in 'Troubleshooting' started by Magnumr, Aug 26, 2015.

  1. Magnumr

    Magnumr Member

    Joined:
    Sep 2, 2014
    Messages:
    40
    Likes Received:
    5
    Please see attached my 15 hr print. the first 11 hrs looked good, and then i went to work something else happened.. and I came home to this

    printed using PLA at 230 with 0.1 infill and 3 perimeter, top and bottom, using MC
    printer is Robo KS with no mods what so ever

    [​IMG]
    [​IMG]

    green arrow (Y direction)
    red arrow (X direction)

    how do I fix the what is going on in Y direction?
    what could be cause of the top half going haywire?
     
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    That's a pretty serious case of under extrusion. Might have burst the PTFE liner. Is it leaking filament out?
     
  3. Magnumr

    Magnumr Member

    Joined:
    Sep 2, 2014
    Messages:
    40
    Likes Received:
    5
    where is the PTFE liner located? I do not see any filament leaking out.
     
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    It's inside the peek body. I assume you have a grey body w/ brass head?
     

Share This Page