Hmm.. printing slanted..

Put it back (took me an hour, the angles are horrible, next time will take the thing apart!)
Didnt have any loctite so will have to deal with it if/when it happens again... doing another test print... will post result.

 

Test print done

Sent from my Pixel XL using Tapatalk

 

its doing better now, but need to keep an eye on those set screws.... some are hard to get at. Other than that its printing away a large project now with many pieces in ABS. Still have the heat bed issue though, so have to use ABS juice.

 

I had one come loose and start chewing into that inner plastic lip. I still had the printer in the house, so thankfully I heard it. Glad your printer is now on the right angle!

 

THANK YOU SO MUCH! I had several prints fail -- was trying to print these cute little flying toasters that are NOT supposed to be slanted. I thought it was a slicing error too, until I printed old (and even the included sample) gcode that had the same issue. I was wiggling my bed like there was no tomorrow! but alas, it was one of the front left screws that disappeared and was hiding under the base.