1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Honeycomb look

Discussion in 'General Questions' started by David Avila, Apr 13, 2017.

  1. David Avila

    David Avila Member

    Joined:
    Mar 16, 2016
    Messages:
    69
    Likes Received:
    5
    just a simple question how can I get this honeycomb look like the pic with my robo 3d thanks?

    Screen Shot 2017-04-13 at 10.25.37 AM.png
     
    #1 David Avila, Apr 13, 2017
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    That just looks like a triangular infill with a very limited number of surface layers using two colors, so infill is black, perimeters are natural (translucent), can't actually be done on a Robo easily.
     
    #2 WheresWaldo, Apr 13, 2017
  3. David Avila

    David Avila Member

    Joined:
    Mar 16, 2016
    Messages:
    69
    Likes Received:
    5
    how about like this could this be done, thanks

    Screen Shot 2017-04-13 at 10.56.47 AM.png
     
    #3 David Avila, Apr 13, 2017
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Yes, you could just make sure that you use just one or two bottom layers then triangular fill Even opaque filaments will be translucent with so few layers.
     
    #4 WheresWaldo, Apr 13, 2017

Share This Page