1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

How do I replace the thermistor?

Discussion in 'Mods and Upgrades' started by Nathan Elverud, Dec 22, 2016.

  1. Nathan Elverud

    Nathan Elverud New Member

    Joined:
    Dec 22, 2016
    Messages:
    24
    Likes Received:
    1
    I bought an R1+ a week ago and think I shorted the thermistor this morning trying to remove a jam.

    I've been looking at buying RioBrand 100Kohm NTC Thermistors. I need to know if they will work and how to install them. The whole printer is stock.

    The reason I think I shorted the thermistors is because it says the extruder is at 357 °C when it's actually cold. The heated bed is fine.
     
    #1 Nathan Elverud, Dec 22, 2016
    Last edited: Dec 22, 2016
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Hi Nathan, they won't work the r1+ has a proprietary canister thermistor. You'll have to contact robo for a replacement
     
    #2 Geof, Dec 22, 2016

Share This Page