1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

How to clean stuck PC filament from the buildtak sheet

Discussion in 'General Questions' started by DavidR, Feb 7, 2018.

  1. DavidR

    DavidR Member

    Joined:
    Jan 3, 2018
    Messages:
    78
    Likes Received:
    13
    eSun ePC in particular, I have canceled the print early (basically first layer). I have found in general that it won't even budge unless the bed is heated. Even with the bed temp at 100 I'm having difficulty getting it off, is there an easier way to do this?
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    David,
    PC is what buildtak is made out of so it sticks HARD. if you cant get it all off you'll need to sand down the build tak. going forward use a bit of glue stick to negate to much adhesion.
     
    mark tomlinson likes this.

Share This Page