1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Interesting article on fill patterns and print strength

Discussion in 'Off Topic' started by WheresWaldo, Oct 13, 2016.

  1. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    #1 WheresWaldo, Oct 13, 2016
    mark tomlinson likes this.
  2. Caleb Cangelosi

    Caleb Cangelosi Member

    Joined:
    Nov 3, 2015
    Messages:
    71
    Likes Received:
    4
    So does this article make you want to use a honeycomb infill pattern at less than 100% infill, if you didn't already?


    Sent from my iPhone using Tapatalk
     
    #2 Caleb Cangelosi, Oct 13, 2016
  3. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    I saw that earlier. Interesting read. I was surprised by the percentage difference in strength. I'm just now starting to play with different types of infill since Cura was just one type prior to 2.0.
     
    #3 danzca6, Oct 13, 2016

Share This Page