1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Interrupted Print

Discussion in 'Troubleshooting' started by Qaytin, Aug 6, 2017.

Thread Status:
Not open for further replies.
  1. Qaytin

    Qaytin New Member

    Joined:
    Aug 25, 2016
    Messages:
    11
    Likes Received:
    1
    I printed 22 peaces on my 3D R that came out perfect and while I was printing the vary last peace (of course) when the printer stop right in the middle of print the message on master control slicer was "Printer not communicating unknown reason" or some thing like it. I shut down both printer and the slicer restarted them both. How ever when the I restarted the print it came out at haft the thickness as it should of. I tried adjusting the Z Offset but it didn't work.
     
    #1 Qaytin, Aug 6, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Sounds like a clog. There are some threads on here that discuss options for clearing a clog as well as preventing it if you are using PLA>
     
    #2 mark tomlinson, Aug 20, 2017
  3. Qaytin

    Qaytin New Member

    Joined:
    Aug 25, 2016
    Messages:
    11
    Likes Received:
    1
    It solved it self
     
    #3 Qaytin, Aug 24, 2017
Thread Status:
Not open for further replies.

Share This Page