1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Is it possible to redefine the points that the autolevel routine uses?

Discussion in 'Troubleshooting' started by Morichalion, Oct 1, 2016.

Thread Status:
Not open for further replies.
  1. Morichalion

    Morichalion Member

    Joined:
    Dec 1, 2015
    Messages:
    79
    Likes Received:
    25
    I'm running a print to test a fix I made to try and resolve y-axis shift issues. Damn thing is, my fix seems to be running into something during the G29 bed probe on the last y-axis movement. If I had those points ~ 10 millimeters closer, there would be no collision.

    So, is this possible?
     
    #1 Morichalion, Oct 1, 2016
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Sounds like a mechanical issue stopping y from travel ?
     
    #2 Geof, Oct 1, 2016
  3. Morichalion

    Morichalion Member

    Joined:
    Dec 1, 2015
    Messages:
    79
    Likes Received:
    25
    Yeah, something was where it wasn't supposed to be. Now it's where it's supposed to be. All is well.
     
    #3 Morichalion, Oct 1, 2016
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Id bet on the bed wires or clamp being loose.
     
    #4 Geof, Oct 1, 2016
  5. Morichalion

    Morichalion Member

    Joined:
    Dec 1, 2015
    Messages:
    79
    Likes Received:
    25
    Wires. ><
     
    #5 Morichalion, Oct 1, 2016
    Geof likes this.
Thread Status:
Not open for further replies.

Share This Page