1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
  2. Please message Harry if you experience any technical difficulties while using the forum. Thank you.

is shaking of the bed while printing on thee y axis normal?

Discussion in 'General Questions' started by felipe fomez, Aug 3, 2017.

  1. felipe fomez

    felipe fomez Member

    Joined:
    May 19, 2015
    Messages:
    41
    Likes Received:
    0
    my bed tends to shake while printing on y axis. is some shaking normal?
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    4,502
    Likes Received:
    1,507
    Video ?
     
  3. KTMDirtFace

    KTMDirtFace Well-Known Member

    Joined:
    May 18, 2015
    Messages:
    1,204
    Likes Received:
    428
    Mine did this when a bearing was bound up. unhook the belt and move it by hand see if it binds. Mine was binding and vibrating.
     
    mark tomlinson likes this.

Share This Page