1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Jammed hotend Robo r2

Discussion in 'Troubleshooting' started by plgzuz, Aug 28, 2017.

  1. plgzuz

    plgzuz New Member

    Joined:
    Aug 27, 2017
    Messages:
    1
    Likes Received:
    0
    i need help. My filament would not extrude. Called tech support. Had me take off the hotend and there was filament broken off. Got the hotend back in, but cannot figure out how to get the wires connected. Could someone post a picture of the hotend with the wires connected. Would be much appreciated.
    Robo r2 printer.
     
    #1 plgzuz, Aug 28, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Moving this to the R2 section. You can try my thread in the C2 section, the connections are the same for the C2/R2.
     
    #2 mark tomlinson, Aug 28, 2017
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #3 mark tomlinson, Aug 28, 2017
    Geof likes this.

Share This Page