1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Kitchener - Waterloo member

Discussion in 'Canada' started by Michael Grace, Feb 10, 2018.

  1. Michael Grace

    Michael Grace New Member

    Joined:
    Jan 12, 2018
    Messages:
    2
    Likes Received:
    0
    Picked up a Robo 3D 1 + on a boxing day sale. Been printing some small items with varied success. Having problems with bed adhesion on a lot of things. The recommended Aqua Net hair spray isn't available in most stores and online it is $48 CDN +. Tried a few other sprays and gells with limited success using PLA. Tried some TPE90A flexible, total disaster and it is one of the stiffer TPE/TPU formulations.
     
  2. mark tomlinson

    mark tomlinson ¯\_(⊙︿⊙)_/¯
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    18,212
    Likes Received:
    6,064
    Add the PTFE tube that has been described and slow way down.
    As in 15 mm/sec or slower. The GregsWade is poorly suited for Flexibles
     

Share This Page