1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

lack of support material

Discussion in 'Projects' started by Deadwood, Nov 22, 2013.

  1. Deadwood

    Deadwood Active Member

    Joined:
    Jul 4, 2013
    Messages:
    119
    Likes Received:
    29
    Hi all
    who knows anything about designing your own parts, I have made bracket to fix a broken toy it seems to slice ok but when I try to print it it prints upside down (tried turning it over in sketchup but still the same problem and have run it through nettfab) and even though I have enabled support it does 2 tiny bits in the wrong place . any ideas as I am a complete 3 d design novice
     

    Attached Files:

  2. Printed Solid

    Printed Solid Volunteer Admin
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    1,605
    Likes Received:
    1,003
    You had a few holes in it. They can be fixed with the automatic repair in netfabb easily. Here's the orientation I would print it in. It should only need to print a little support under the 4 bosses. If it's not doing that, you might have something off in your slicer settings that needs troubleshooting.
    Capture.JPG
     

Share This Page