1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Lightbulb for 3D Prints

Discussion in 'General Questions' started by Jutte, Jun 19, 2016.

  1. Jutte

    Jutte Member

    Joined:
    Apr 5, 2016
    Messages:
    47
    Likes Received:
    19
    #1 Jutte, Jun 19, 2016
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    All depends on what your looking to do, those are neat but pretty expensive for me

    I use a tea light led for pretty things that light up, if it's something that will be powered on all the time I use LEDs wired to a 9v :).
     
    #2 Geof, Jun 19, 2016
    Jutte likes this.
  3. Jutte

    Jutte Member

    Joined:
    Apr 5, 2016
    Messages:
    47
    Likes Received:
    19
    Thanks. The item I am trying to light up right now is a lithophane lamp which has a top cover. LED tealights don't seem to be bright enough to show the photo effect, and regular ones would melt the top. I found a jack-o-lantern light that is pretty bright but I don't like the flickering effect. I got a small tap light from a dollar store but it's not quite bright enough.
     
    #3 Jutte, Jun 19, 2016

Share This Page