1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partial Answer lines on prints

Discussion in 'Troubleshooting' started by David Avila, Feb 22, 2018.

  1. David Avila

    David Avila Member

    Joined:
    Mar 16, 2016
    Messages:
    69
    Likes Received:
    5
    I have a robo 1 and robo 1 plus and I'm getting lines on both printers on only this print I have same print but wider and no lines

    setting are
    layer hight 0.2
    temp 210 and 50
    speed 65
    infill .85

    IMG_0480.jpg
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    looks like under extrusion. Do you use an oiler?
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    I would suspect a model issue. Specifically scaling... the slicer has a problem with something scaling.
     
    Geof likes this.
  4. David Avila

    David Avila Member

    Joined:
    Mar 16, 2016
    Messages:
    69
    Likes Received:
    5
    tried the oiler and different file same issue, I want to calibrate but dont know how to change the settings, I use matter control with a xxl lcd
     
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    This is why I suspect the model. Not a generic issue that would affect all prints. Oiler, calibration, those are both more generic issues. At a minimum try another slicer, but I would run the model through some repair / test utilities first.
     
  6. David Avila

    David Avila Member

    Joined:
    Mar 16, 2016
    Messages:
    69
    Likes Received:
    5
    Ok I don
    Ok I dont know how to adjust the number for the calibration. My average for 100mm was 89.99 so I'm under extrusion. How do I adjust the number in the firmware? Thanks
     
  7. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Here is your formula;

    ( Original_ESteps * 100 ) / Number_you_measured = New_ESteps
     
    mark tomlinson and Geof like this.
  8. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    MathBurns.jpg

    (just kidding)
     

Share This Page