1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Looking for some help / Cura profile for Robo R1 v15.04 for OctoPrint

Discussion in 'Off Topic' started by WheresWaldo, May 10, 2019.

  1. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    I am looking for old versions of cura slicing profiles for the R1 or R1 plus.
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,957
    Likes Received:
    7,344
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,957
    Likes Received:
    7,344
    try these
     

    Attached Files:

  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Those are material profiles, I need the slicing profile to add to CommunityOS
     
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,957
    Likes Received:
    7,344
    OK, that is the extent of "stuff" I have specific to any version of Cura :)
     

Share This Page