1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Made and unboxing video of my Robo r2 and did initial set up

Discussion in 'Show and Tell' started by Pandariot779, Jun 3, 2017.

  1. Pandariot779

    Pandariot779 Member

    Joined:
    Dec 1, 2015
    Messages:
    36
    Likes Received:
    3


    Hey I made an unboxing video and hope you guys like it. I also did a test print in the following video and the video after i printed out the boden tube clip.

    I would like to say i enjoy my printer. I didnt run to any issues putting it together and running a print. Just make sure you level the bed perfectly using the fine tune command in the utilities wizard.
     
    #1 Pandariot779, Jun 3, 2017
    mark tomlinson likes this.
  2. fredm

    fredm Member

    Joined:
    May 30, 2016
    Messages:
    110
    Likes Received:
    7
    I stumbled across this yesterday.
    I occasionally check robos website to see if the r2's are shipping, it still says "pre order"
    So I was surprised to see an unboxing.
    thanks for taking the time to make the video.
     
    #2 fredm, Jun 5, 2017
  3. Kilrah

    Kilrah Well-Known Member

    Joined:
    Apr 18, 2017
    Messages:
    498
    Likes Received:
    332
    It's the Kickstarters that are shipping.
     
    #3 Kilrah, Jun 5, 2017

Share This Page