1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

My printer keeps stopping mid print

Discussion in 'Troubleshooting' started by Leyth Toubassy, Apr 8, 2019.

  1. Leyth Toubassy

    Leyth Toubassy New Member

    Joined:
    Apr 7, 2019
    Messages:
    1
    Likes Received:
    0
    At 55% my printer simply stops moving and extruding and just sits on the model still heated up, it also remains on the print in progress screen and displays the progress bar, percent, and job name but no estimated time remaining, any help would be much appreciated.
     
    #1 Leyth Toubassy, Apr 8, 2019
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I'd start with reflashing your image to the R2's Raspberry Pi. If that doesn't fix it then I'd look to see if another slicer (or gcode causes the same issue). In Octoprint (the web browser) there should be a communication log. If there is an error it will be in there and you can copy past here for us to see. You cant close the window to turn off the printer, leave it up and in the state of error.
     
    #2 Geof, Apr 9, 2019

Share This Page