1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Need to Disassemble Hot End and problems with z-height

Discussion in 'Troubleshooting' started by CrazyCat, Feb 15, 2015.

  1. Ben R

    Ben R Active Member

    Joined:
    Nov 21, 2014
    Messages:
    651
    Likes Received:
    89
    Yup. Problem... Mitigated. Thats way wrong. If you have a NEW robo. 5/16 rods would be different
    Fix and test with a test box or something. No need to print a vast pentagon
    In matter control it should tell u what firmware you have. Wonder if you got a "new reconditioned" one that someone flashed the wrong firmware on... Q/A probs
     
  2. CrazyCat

    CrazyCat Member

    Joined:
    Feb 5, 2015
    Messages:
    85
    Likes Received:
    3
    ok It should be a goddamn new robo. I didnt pay for a refurbished one lol. I changed the steps to the 2560 that you suggested and will give it a go.
     
  3. CrazyCat

    CrazyCat Member

    Joined:
    Feb 5, 2015
    Messages:
    85
    Likes Received:
    3
    ROBO3DR1v2 is what it says the firmware is. Says its up to date.
     
  4. CrazyCat

    CrazyCat Member

    Joined:
    Feb 5, 2015
    Messages:
    85
    Likes Received:
    3
    Well the corners of the box warped causing some issues but as for the actual laying of the layers as it gets higher is looking much better. Increased the bed temp and gonna try again.
     
  5. CrazyCat

    CrazyCat Member

    Joined:
    Feb 5, 2015
    Messages:
    85
    Likes Received:
    3
    Where and how can I flash some new firmware?
     
  6. CrazyCat

    CrazyCat Member

    Joined:
    Feb 5, 2015
    Messages:
    85
    Likes Received:
    3
    ignore stupid question
     
  7. CrazyCat

    CrazyCat Member

    Joined:
    Feb 5, 2015
    Messages:
    85
    Likes Received:
    3
    I flashed the firmware listed on the site. Now Mattercontrol shows that it needs to be updated, but I am going to ignore it and see what happens as the eeprom settings look correct now.
     
  8. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Smart move.
    I'd suggest you only update the firmware if there is a specific issue you are trying to solve that you know it will solve.

    If it ain't broke...
     
    2 people like this.
  9. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
  10. CrazyCat

    CrazyCat Member

    Joined:
    Feb 5, 2015
    Messages:
    85
    Likes Received:
    3
    well the test cube went great, but my print....not so much. Gonna have to do the sit and stare. Just when you think you got it going on lol
     

Share This Page