1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

new block and 0.4 nozzle bronce for PLA

Discussion in 'Mods and Upgrades' started by Mr Wire, Apr 16, 2019.

  1. Mr Wire

    Mr Wire Member

    Joined:
    Jun 7, 2017
    Messages:
    46
    Likes Received:
    6
    hello
    ive changed the original aluminum block ( a little bigger ) and a 0.4 nozzle ( ive read is the stock size)
    do i need to change any settiing at mattercontrol from the original ones?
    It extrudes ok, but i cannot print first layer since the modification.
    it makes a noise on the stepping motor
    an the filament looks like bitten
     

    Attached Files:

    #1 Mr Wire, Apr 16, 2019
    Last edited: Apr 16, 2019

Share This Page