1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

New Cura 2.x slicer and material profiles

Discussion in 'Software' started by WheresWaldo, May 21, 2017.

  1. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Feb 18, 2015
    Likes Received:
    Just in the past two weeks additional material profiles and upgraded slicer profiles for Cura 2.x. They are on the Robo3D GITHUB repository located specifically here:

    I cannot tell you how to add them to Cura, maybe someone with Cura experience can post instructions.
  2. colton81

    colton81 Active Member

    Feb 21, 2017
    Likes Received:
    When you are in Cura you need to click the drop down for profiles and manage profiles then click import and import each profile individually. For materials click the drop down for materials and click manage materials then import materials one by one. The below is a link for the mac install for cura but the same rules apply for windows just skip to step 4

    mark tomlinson and WheresWaldo like this.

Share This Page