1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

New Cura Version Settings for Robo3D R1+

Discussion in 'Software' started by Toro1966, Jul 22, 2016.

  1. Toro1966

    Toro1966 Active Member

    Joined:
    Jun 23, 2016
    Messages:
    398
    Likes Received:
    78
    Hey guys - want to try out Cura but I have no idea how to set it up for this printer. I know there is a tutorial for version 15.4 - I believe. That said, Cura has a new version out that doesn't proscribe to that convention - the number is 2.1.2 - and it is different than the 15.4 so I am not sure where to start. Would appreciate any assistance. Thanks!
     
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
  3. Toro1966

    Toro1966 Active Member

    Joined:
    Jun 23, 2016
    Messages:
    398
    Likes Received:
    78
    I saw that - is the beta the same as the release version - or close enough? Thanks!
     
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Yes, and maybe if you ask nice @danzca6 can verify the files for you. He seems most familiar with Cura.
     
    Geof likes this.
  5. Toro1966

    Toro1966 Active Member

    Joined:
    Jun 23, 2016
    Messages:
    398
    Likes Received:
    78
    Thanks Waldo - I'll definitely ask him!
     

Share This Page