1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved New printer, printed for 20 minutes...

Discussion in 'Troubleshooting' started by mindphunk, Mar 15, 2018.

  1. mindphunk

    mindphunk New Member

    Joined:
    Mar 15, 2018
    Messages:
    19
    Likes Received:
    2
    Hi guys. I just picked up a new robo r1 plus. It printed for 20 minutes (pla), temps were the stock pla temps 210/60 I think. MatterContol stopped the print saying there was a hardware malfunction and now the bed temp reads about 250 whether it's plugged in or not. I don't believe the wires are crossed because I wouldn't be able to print pla at 60 degrees, right? There no scorch marks on the bundle attached to the bed. Ideas?
     
    #1 mindphunk, Mar 15, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Thermistor is bad or wires are. Shorted most likely.
     
    #2 mark tomlinson, Mar 15, 2018
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    There is a short in the thermistor wiring. Check the cable going to the thermistor on the hotend.

    What he said :oops:
     
    #3 WheresWaldo, Mar 15, 2018
    mark tomlinson likes this.

Share This Page