1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved New R1+ aborting print with error

Discussion in 'Troubleshooting' started by dbvanhorn, Jan 6, 2018.

  1. dbvanhorn

    dbvanhorn Active Member

    Joined:
    Feb 15, 2015
    Messages:
    166
    Likes Received:
    36
    \READ: Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)

    I get the first layer ok, then on the second layer a noise (source unknown) and this.

    Any ideas?
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
  3. dbvanhorn

    dbvanhorn Active Member

    Joined:
    Feb 15, 2015
    Messages:
    166
    Likes Received:
    36
    Nothing shows up in the log file, and the temperature plot shows no issues.
     
  4. dbvanhorn

    dbvanhorn Active Member

    Joined:
    Feb 15, 2015
    Messages:
    166
    Likes Received:
    36
    It's getting more interesting. It's happening at random times, sometimes just at the beginning, sometimes a couple layers in.
    The onboard lights go dark.

    The power supply is plugged into 110V, and I unplugged the system and cycled the voltage selector from 110V to 220 and back just to be sure.

    Trying another run, but every time it fails, it does so without any temperature alarm in the log file.

    This one is brand new, just arrived from Robo yesterday.

    Might be the thermal cutoff. I will try more cooling to the electronics. Its about 70 here
     
    #4 dbvanhorn, Jan 6, 2018
    Last edited: Jan 6, 2018
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    You will never see the temperature change that triggers that error from the firmware.
    It happens too quick for an external GUI to reflect it.
    If everything is shutting down it is the thermal runaway safety kicking in
     
  6. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    If everything is going out the fan on the bottom fromt right of the machine isnt working
     
  7. dbvanhorn

    dbvanhorn Active Member

    Joined:
    Feb 15, 2015
    Messages:
    166
    Likes Received:
    36
    The fan was spinning but not much air was moving. I will probably mod this one like I did my R1 with a larger fan.
     
    WheresWaldo and mark tomlinson like this.
  8. dbvanhorn

    dbvanhorn Active Member

    Joined:
    Feb 15, 2015
    Messages:
    166
    Likes Received:
    36
    Replaced fan with a 100mm fan off to the side, working fine now.
     
    Geof and mark tomlinson like this.

Share This Page