1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

New RAMPS vs old RAMPS wiring for Y axis

Discussion in 'General Questions' started by Clayton, Oct 13, 2015.

  1. Clayton

    Clayton Member

    Joined:
    Sep 15, 2015
    Messages:
    48
    Likes Received:
    7
    In this picture of the RAMPS 1.4 board the Y axis plug in the same ways as all the other axis.
    On my original board only the Y axis is plugged in the opposite way. I've ordered new boards and I want to be sure which way it should be plugged in for my ROBO3D R1+ before I make a mistake. [​IMG]
     
    #1 Clayton, Oct 13, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    If you plug it in backwards the stepper will be reversed.
    Been there. Done that.
    Flip it back.
     
    #2 mark tomlinson, Oct 13, 2015
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    But it should land the same way your original board did.
     
    #3 mark tomlinson, Oct 13, 2015
  4. Clayton

    Clayton Member

    Joined:
    Sep 15, 2015
    Messages:
    48
    Likes Received:
    7
    Ok, on the original board it was the only one reversed. Good to know it wont blow anything up if its reversed.
    Thanks!
     
    #4 Clayton, Oct 13, 2015

Share This Page