1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved No axis are moving during Prints

Discussion in 'Troubleshooting' started by SethAndress, Mar 5, 2019.

  1. SethAndress

    SethAndress New Member

    Joined:
    Mar 5, 2019
    Messages:
    2
    Likes Received:
    1
    I recently upgraded to the E3D v6, after setting everything back up the printer will not move during the print. It will still home and run through the auto bed leveling, but once it starts the actual print it doesn't move.
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,703
    Likes Received:
    2,313
    That is very odd. Typically a mechanical issue will not move at all (and normally not all axis). If its only not working during printing are you getting any errors in the gcode terminal? Kind of sounds like a slicer issue but one thing at a time:D
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    22,363
    Likes Received:
    7,171
    Get to the point where it is stopped and has gotten to temperature then save the GCode terminal to a text file so you can sort through the entire thing searching for the word ERROR.
     
    Geof likes this.
  4. SethAndress

    SethAndress New Member

    Joined:
    Mar 5, 2019
    Messages:
    2
    Likes Received:
    1
    I just started a print to try to replicate the issue, but it seems like it's working fine now. I'll post back on here If it happens again.
     
    Geof likes this.

Share This Page