1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered No Lights

Discussion in 'Troubleshooting' started by CCJ, Dec 28, 2018.

  1. CCJ

    CCJ New Member

    Joined:
    Feb 23, 2016
    Messages:
    9
    Likes Received:
    1
    Just unpacked a recently purchased R1+ and the lights aren't working. The right one flickers faintly and the left one is dark.
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Probably bad connections.
    Make sure it prints OK, the lights are cosmetic :)
     
    Geof likes this.
  3. CCJ

    CCJ New Member

    Joined:
    Feb 23, 2016
    Messages:
    9
    Likes Received:
    1
    Going to check if it prints and already checked all of the wires to the board. Yeah the lights are cosmetic, but kinda useful in a dark basement. :)
     
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    They should absolutely work -- I get it, but just want to make sure it is otherwise functional. Shipping is rough on assembled printers.
     

Share This Page