1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved No power

Discussion in 'Troubleshooting' started by Nathanfish, Dec 16, 2016.

  1. Nathanfish

    Nathanfish Active Member

    Joined:
    Aug 6, 2015
    Messages:
    306
    Likes Received:
    34
    So i came in last week to my printer shut off and something smelling fried. My first thought was my power supply so i switched that out. Still no power. Next i swapped out the Arduino and ramps boards. Still nothing. Now i'm lost. What else could be the problem with this?
     
    #1 Nathanfish, Dec 16, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Did you check the A/C fuse (it is in the plastic bit where the A/C cord plugs in)
     
    #2 mark tomlinson, Dec 16, 2016
    Geof and Nathanfish like this.
  3. Nathanfish

    Nathanfish Active Member

    Joined:
    Aug 6, 2015
    Messages:
    306
    Likes Received:
    34
    Wow that was it... haha. where do i even get one of these at?
     
    #3 Nathanfish, Dec 16, 2016
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Glass fuses at Lowes or the devil incarnate Home Depot.
     
    #4 WheresWaldo, Dec 16, 2016
    Nathanfish and Geof like this.
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Good luck. Buy more than one and be prepared that there may be a larger problem if that fuse blew
     
    #5 mark tomlinson, Dec 16, 2016
    Nathanfish and Geof like this.
  6. Nathanfish

    Nathanfish Active Member

    Joined:
    Aug 6, 2015
    Messages:
    306
    Likes Received:
    34
    Well i do have all new boards and new 400 watt power supply so hopefully anything that was messed up has been replaced by those. Can't seem to connect to it right now tho for some reason.
     
    #6 Nathanfish, Dec 16, 2016

Share This Page