1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved No Power

Discussion in 'Troubleshooting' started by ODBman, Nov 17, 2019.

Thread Status:
Not open for further replies.
  1. ODBman

    ODBman New Member

    Joined:
    Jul 3, 2016
    Messages:
    3
    Likes Received:
    2
    I had printed a project. When I woke up and checked the project it was great. So I removed the print and turned off the printer. Now, I have tried to turn the printer back on and nothing. No lights, no sounds no nothing. I changed where I plugged it for power, nothing. Am I'm I looking and buying a new power supply? Or is there something else to check? Thanks. Les
     
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,665
    Likes Received:
    2,291
    There is a fuse where you plug in the power cord- may check that. Odd that it would below but possible.
     
    mark tomlinson likes this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    21,516
    Likes Received:
    7,059
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    21,516
    Likes Received:
    7,059
    If the fuse is good then you may have a bad power supply.
    If you have a voltmeter the next step would be to check the power coming out of the power supply -- we can assist you with that if you fuse is good.
     
  5. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,864
    Likes Received:
    3,559
    mark tomlinson likes this.
  6. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,665
    Likes Received:
    2,291
    12v 30 amp is what I use in all mine - more doesn’t hurt
     
  7. ODBman

    ODBman New Member

    Joined:
    Jul 3, 2016
    Messages:
    3
    Likes Received:
    2
    I did check the fuse at the plug, it is good. I looked for a green light glowing on the Power supply - it did not glow at all. The fuse on the power supply board is good so something else must be bad on the Power supply. Thanks, I did order a new power supply.
     
    mark tomlinson likes this.
  8. ODBman

    ODBman New Member

    Joined:
    Jul 3, 2016
    Messages:
    3
    Likes Received:
    2
    I received a replacement power supply today, I installed it this evening and my printer is back up and running, Thanks for your help!!!
     
    mark tomlinson likes this.
Thread Status:
Not open for further replies.

Share This Page