1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Nylon 910 with Simplify3D

Discussion in 'General Questions' started by Jeff Hamilton, Jan 14, 2017.

  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Yea, bump the bed heat a little.
    I can't recall off the top of my head if it strings cold or hot.
    try raising the extrusion temp a few degrees and see if that helps.

    Some of the nylon filaments were backwards that way.
     
    Ryan TeGantvoort likes this.

Share This Page