1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

OctoPi upgrade?

Discussion in 'General Questions' started by Erica Lindström, Nov 8, 2017.

  1. Erica Lindström

    Erica Lindström New Member

    Joined:
    Jul 7, 2017
    Messages:
    26
    Likes Received:
    3
    I use Cura for arranging my prints evenly on the surface of the bed. then I send it to the printer and press the button "go to Octo Print". A web page loads with a local adress for my printer (lots of numbers) and the printing starts.

    Now I have the following message on Octo Print:

    "If you are running OctoPi 0.13 or later you can now stop reading, this only concerns OctoPi 0.12 or older :)

    Note: You can find out your OctoPi version by SSHing into your OctoPi instance and then doing a cat /etc/octopi_version:
    pi@octopi ~ $ cat /etc/octopi_version
    0.12.0"

    This rose several questions for me:
    Is OctoPi and Octo Print the same thing?
    What is SSHing?
    How do I do it on a Mac?

    Any help is appreciated.
     
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Ignore the error, it is just a general announcement not an actual error message, Robo does not use Octopi version 0.12 or prior.
     
    Kilrah and Geof like this.

Share This Page