1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Oops, I should have paid more attention

Discussion in 'Troubleshooting' started by Gabriel Moore, Jul 30, 2016.

Thread Status:
Not open for further replies.
  1. Gabriel Moore

    Gabriel Moore Member

    Joined:
    Nov 3, 2015
    Messages:
    45
    Likes Received:
    16
    I an upgrading the hotend on a robo r1+. Following instruction on Printed Solid site for the e3d and youtube, I started by pulling all the wires I was told. My question, knowing little about electronics, D9 and D10 - D10 is just a standoff where D9 is a full plug. Is the hot end really pushing power thru the d10 connector and the larger D9 for the fan? If so I need to get some new connectors, because d10 looks nothing like it does on the youtube videos and how to guides I have seen.

    Thanks in advance for any help.



    20160730_150615.jpg
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Geof likes this.
  3. Gabriel Moore

    Gabriel Moore Member

    Joined:
    Nov 3, 2015
    Messages:
    45
    Likes Received:
    16
    Thank you. I searched all over for e3d install r1+v1, didn't think to look for just the board. Brain shut off when I got frustrated.

    He had a great photo.
    Robo3D R1 +Plus Board.jpg
     
    mark tomlinson likes this.
Thread Status:
Not open for further replies.

Share This Page