1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Oops something unplugged

Discussion in 'Troubleshooting' started by Cyberwitch, May 26, 2021.

  1. Cyberwitch

    Cyberwitch New Member

    Joined:
    May 26, 2021
    Messages:
    4
    Likes Received:
    0
    hi there, hoping someone can help, we have a robo 3d and one if the pin plugs has come of the x axis connector and I am not sure where it plugs in
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Can you post a picture? You will need to use something like flickr or imagur (because you can't post pictures here yet).

    Post a link to the picture and I'll see what you need :)
     
  3. Cyberwitch

    Cyberwitch New Member

    Joined:
    May 26, 2021
    Messages:
    4
    Likes Received:
    0
    Thank you, its all new to me I bought it a while back and gave up lol, but just bought new filament to try again
     
  4. Cyberwitch

    Cyberwitch New Member

    Joined:
    May 26, 2021
    Messages:
    4
    Likes Received:
    0
    It says I can't add a link but can upload a file 20210526_200328.jpg
     

    Attached Files:

  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    See if this helps:

    Robo3D R1 +Plus Ramps Board (labeled).jpg
     
  6. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    If you plug it in and the motor runs backward -- flip the plug on the board 180 degrees (if you plug it in backwards, the motor will run backwards)
     
  7. Cyberwitch

    Cyberwitch New Member

    Joined:
    May 26, 2021
    Messages:
    4
    Likes Received:
    0
    Thank you but my board doesn't look like your picture, so I'm not sure where to plug it in, there's one place that looks possible but what if I plug it in the wrong one
     
  8. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Picture of you entire board then please.
    The one I posted is the standard board for the R1+

    If you plug it into a motor port the worst you can do is plug it in backwards and I already addressed that :)

    If you plug it into something else that might be a problem.
     
  9. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Since it could be R1 beta, R1, R1+ you need to be more specific in order for me to post a picture f your board :)
     

Share This Page